|
|
Sheet Metal Fabrication / Metal Forming |
Below are examples of the types of sheet metal fabrication/metal forming work we have done in the past. |
Re-skining a C-180 |
C-180 left side |
C-180 right side |
Fabrication of Waco 10 cowl |
We formed this cowl using our English Wheel and the original factory drawings. Underneath the cowling is an OX-5 water-cooled V8 engine. |
Fabrication of an oil tank |
We fabricated and welded these Stinson Tri-Motor 6000A oil tanks out of aluminum because the originals were unservicable and of course unavailable. |
Fabrication of engine nacelles |
We hand formed these Kreutzer K-5 engine nacelles on our English wheel and later swirl finished. |
Rebuilt center section |
We totally rebuilt this center section on a Fairchild F-45. |
More metal forming work |
Engine Nacelle |
Wing Root Fairing |
These are part of a Stinson Tri-Motor 6000A and were hand formed on our English Wheel. |
Bump cowl & wheel pant rebuilt |
Bump Cowl |
Wheel Pant |
Waco YMF Bump Cowl and Wheel Pant rebuilt after a ground loop. |
Copyright 2008 H.O. Aircraft, Inc. |